How to Use THE FUNKY BAG

1. Mark the location on your switchgear where you want to drill.
2. Open up switchgear "CAUTION - MAY BE LIVE or HOT".
3. Simply attach "THE FUNKY BAG " to the bottom side of the location where you are drilling. (e.g., switchgear, electronic equipment, transformer, etc.)
4. When the tool is secure - simply slide into proper location, so that the tool is centered on your mark.
5. Drill your hole using a unibit or small hole saw (½“or ¾”).
6. Punch out the desired hole using a hole punch.

Warning!

• Always wear gloves when working in live or hot switchgear
• Make sure the tool is properly attached to conductive surface before using.
• Make sure tool is in proper location before using.
• Do not use with cutting oils.
• Make sure the tool is kept in a dry place at all times.
• Make sure tool is dry before using.
• Should any of the components break - DO NOT USE TOOL.
• Do not use tool if damaged (e.g., leather is torn or plastic broken).